Printer Setup and Operation
Load the Media—Cutter Mode or Delayed Cut Mode
54
P1088680-001 ZT600 Series™ User Guide 5/22/17
3. Rotate the media guide adjustment knob as shown until the media guide slides all the way
out.
4.
Caution • The printhead may be hot and could cause severe burns. Allow the
printhead to cool.
From the media spindle (1), feed the media under the dancer assembly (2), through the
media sensor (
3), and under the printhead assembly (4). Slide the media back until it
touches the inside back wall of the media sensor.
To Next Page
Loading...