85
Printer Setup and Operation
Install the Printer Driver and Connect the Printer to the Computer—Ethernet
5/22/17 ZT600 Series™ User Guide P1088680-001
Configuring the printer with your LAN information (if necessary)
If your printer connected to your network automatically, you do not need to complete this
section. Continue with Adding a Printer from the Zebra Setup Utilities Screen on page 86.
7. Connect the printer to your computer using a USB, serial, or optional parallel port as
instructed in Connect a Computer to the Printer’s USB Port on page 71 or Connect a
Computer to the Printer’s Serial or Parallel Port on page 75.
8. Configure the following printer settings. You can change the values through the Zebra
Setup Utilities (click Configure Printer Connectivity on the Zebra Setup Utilities screen)
or by the ways listed at the following links. Contact your network administrator for the
proper values for your network.
• WIRED IP PROTOCOL on page 146 (change the value from ALL to PERMANENT)
• WIRED GATEWAY on page 145 (match the gateway value of your LAN)
• WIRED SUBNET MASK on page 144 (match the subnet value of your LAN)
• WIRED IP ADDRESS on page 143 (assign a unique IP address to the printer)
To Next Page
Loading...