Use of ROPS and Seat Belt
Precaution to Avoid Tipping
Safe parking of the tractor
Handle Fuel Safely Avoid Fires
The Roll Over Protective Structure (ROPS) has been
certified to industry and / or government standards. Any
damage or alternation to the ROPS, mounting hardware,
or seat belt voids the certification and will reduce or
eliminate protection for the operator in the event of a roll-
over. The ROPS, mounting hardware, and seat belt
should be checked after the first 100 hours of tractor and
every 500 hours thereafter for any evidence of damage,
wear or cracks. In the event of damage or alteration, the
ROPS must be 2 replaced prior to further operation of the
tractor.
The seat belt must be worn during machine operation
when the machine is equipped with a certified ROPS
Failure to do so will reduce or eliminate protection for the
operator in the event of a roll over.
HODP012
Do not drive the tractor to places where the tractor may
get stuck or roll over.
Pay attention to holes and rocks in the terrain and all
hidden dangers.
Slow down before making sharp turn.
If you try to drive the tractor from a ditch or waterlogged
terrain where the tractor has got stuck, it may turn over.
Try to avoid these situations.
HODP013
Before working on the tractor; Lower all equipment to the
ground.
Stop the engine and remove the key.
HODP014
Handle fuel with care; it is highly flammable. Do not refuel
the tractor while smoking or near open flame or sparks.
Always stop engine before refueling tractors.
Always keep your tractor clean of accumulated grease,
and debris. Always clean up spilled fuel.
HODP016
To Next Page
Loading...
Need help?
General