GET STARTED / PRINTER CONNECTION
15
Simply right click on them, and choose ‘uninstall’. Make sure that driver les get
removed (tick an option). Then, unplug the USB-cable and plug it again. You should see
‘ZMorph HID’ appear.
?
To make sure that HID connection works, it’s best to open the Device Manager in Windows and
check that no other drivers ‘occupies’ the device. This only happens if you previously used
3d printers on your computer. If you see names similar to:
- Smoothie Virtual Serial Port
- Smoothie DFU
To Next Page
Loading...
