Zmorph 2.0 S - Page 57

MAINTENANCE AND FUNCTION / TOOLHEADS
57
To change extruder temperature settings:
To change extruder callibration:
Open cong le with notepad.
1
Open cong le with notepad.
1
Change:
2
Change:
2
If you exchange extruder to another device that measures temperature
(is equipped with thermistor), make sure to verify BETA values of this thermistor.
They are specied on the device, or in it's documentation. If unsure - ask us.
If beta is dierent, you have to change it in cong le, and restart the machine. Otherwi-
se - the readout might vary and create unwanted eects, such as overheating the plastic.
temperature_control.hotend.beta XXX
extruder.hotend.steps_per_mm YYY
steps_per_mm 100
steps_per_mm 400
(Where XXX is the value)
(Where YYY is the value)
For 175 extruder
For 3.00 extruder
EXAMPLES:
Currently (when using new rmware) you can use 'Select Toolhead' menu in
LCD panel instead of steps above.
!