Zmorph 2.0 S - Page 72

MAINTENANCE AND FUNCTION / TROUBLESHOOTING AND ADJUSTMENTS
72
What is a recommended temperature of print?
Recommended temperature (heads):
235-245°C (ABS)
185-200°C (PLA)
Recommended temperature (table):
100-120°C (ABS)
60 - 70°C (PLA)
135°C (NYLON)
Which elements require most maintenance during normal use ?
Depending on quality of the plastic, users might experience nozzle clogging
in the extruder, which needs to be cleaned ocassionally.
Aer transport, machine might require slight recalibration
(table height).
Whatarethedierencesbetweentheoldandthenewversion(2.0)?
Lighter construction, larger working area (expandable to 300x235mm),
lightweight translucent cover and many minor adjustments helping
to manufacture objects more intuitively.
Dremel type recommended for mounting.
Model - dremel 3000 and 4000 .
Output voltage at extruder.
24V
Is the printer assembled and ready to work right away?
We are sending assembled printer. You start your work from installing
the soware, and can run test prints right aer that.
?
?
?
?
?
?