Zmorph 2.0 S - Page 71

MAINTENANCE AND FUNCTION / TROUBLESHOOTING AND ADJUSTMENTS
71
What is the MAX print speed?
ABS - 75mm/s
PLA - 100mm/s
Higher speed can have a negative eect on print quality.
Increasedfriction,whatshouldIdo?
Find the cause of increased friction.
Turn o the machine and gently move the axes X and Y.
It might be necessary to clean the smooth rods or X axis or Y-axis rails.
You can also slowdown the speed (in the settings of the gcodes
generator) or change acceleration values in the conguration le. If this doesn't
help - contact us.
What is in a jar?
100 ml solution of ABS dissolved in acetone.
Oen calles 'ABS juice' makes prints stick to the table.
IwouldliketobearesellerofZMorph,isitpossible?
Of course , please contact sales at: sales@zmorph3d.com
What determines the quality of the prints ?
Method for generating gcodes ( height of the layer , the amount of plastic)
and nozzle size . You can also replace the nozzle print on dierent size,
which signicantly improves the quality, but increases the time of printing.
Is there a daily / monthly / annual limit of prints?
No there isn't .
?
?
?
?
?
?