2.3. How to Connect the PPM3 to Power and
Communications
CAUTION – Before making any connections, you need to figure out a
good place to put the PPM3 in relation to the patient. This is important in
order to avoid creating a situation where cables are hanging in places
where they could get tangled up or trip someone.
To connect the PPM3 to power use the following procedure:
1. Plug the PPM3 Power Supply into a live outlet.
2. Plug the Power Cable Plug into the Power Connector on the back of the
PPM3 (right hand side). The green Battery Charging LED on the back of
the PPM3 should now be illuminated.
3. Press the On/Off Button on the back of the PPM3. After pressing the
On/Off Button you should hear a chirp accompanied by a flash of the
screen. The Power Indicator LED on the front of the PPM3 should be
illuminated.
4. The screen should then go black for a few seconds until the startup screen
shown in the following figure appears. Then as the main screen appears,
you will hear two startup tones followed by two higher-pitched beeps
To Next Page
Loading...
