ZOE PPM3 - Page 36

2-8 Nightingale PPM3 User's Guide April 2019
Getting Started
The serial port is configured as follows:
Baud rate
38400
Data bits
8
Stop bits
1
Parity
None
Flow Control
None
To connect the PPM3 to an Electronic Medical Record (EMR) system:
1. Connect the Network Cable to the connector labeled on the right side
of the PPM3. Then plug the other end of the Network Cable into PC that
is hosting the EMR software.
Note: For complete details of the communications protocol the PPM3 uses for
interfacing with EMR systems, please refer to the document “PPM3 Data Transfer
Interface” (Part Number 122-0064).
Connecting to the Nightingale MPC Central Station
Connection to the Nightingale MPC Central Station requires a custom Network
Cable from Zoe Medical (Part Number 421-0053).
To connect the PPM3 to a Nightingale MPC:
2. Connect the Network Cable to the connector labeled on the right side
of the PPM3. Then plug the other end of the Network Cable into the wall
plate connector marked "Nightingale Monitoring System."