Chapter 6 Home Networking
eir F1000 Modem User’s Guide
Table 32 Network Setting > Home Networking > Additional Subnet (continued)
Select the checkbox to enable the Device to provide public IP addresses by DHCP server.
Select the checkbox to enable the ARP (Address Resolution Protocol) proxy.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
6.8 The STB Vendor ID Screen
Set Top Box (STB) devices with dynamic IP addresses sometimes don’t renew their IP addresses
before the lease time expires. This could lead to IP address conflicts if the STB continues to use an
IP address that gets assigned to another device. Use this screen to list the Vendor IDs of connected
STBs to have the Device automatically create static DHCP entries for them when they request IP
addresses.
Click Network Setting > Home Networking > STB Vendor ID to open this screen.
Figure 60 Network Setting > Home Networking > STB Vendor ID
The following table describes the labels in this screen.
Table 33 Network Setting > Home Networking > STB Vendor ID
Enter the STB’s vendor ID.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
6.9 The 5th Ethernet Port Screen
If you use a DSL connection, you can configure your Ethernet WAN port as an extra LAN port. This
Gigabit Ethernet port provides faster transmission speeds. Click Network Setting > Home
Networking > 5th Ethernet Port to open this screen.
To Next Page
Loading...
