ZyXEL Communications eir F1000 - Basic (WEP Encryption); No Security

73
eir F1000 Modem User’s Guide
Chapter 5 Wireless
Table 13 Network Setting > Wireless > General (continued)
LABEL
DESCRIPTION
Security Mode
Select Basic (WEP, 802.1X) or More Secure (WPA(2)-PSK, WPA(2)) to add security
on this wireless network. The wireless clients which want to associate to this network must
have same wireless security settings as the Device. When you select to use a security,
additional options appears in this screen.
Or you can select No Security to allow any client to associate this network without any data
encryption or authentication.
See the following sections for more details about this field.
Enable WPS/
WiFi Button
Select this to allow the WPS and WiFi buttons on the rear panel of the Device to control the
corresponding functions. Clear this to disable both buttons.
Apply
Click Apply to save your changes.
Cancel
Click Cancel to restore your previously saved settings.
5.2.1 No Security
Select No Security to allow wireless stations to communicate with the access points without any
data encryption or authentication.
Note: If you do not enable any wireless security on your Device, your network is
accessible to any wireless networking device that is within range.
Figure 34 Wireless > General: No Security
The following table describes the labels in this screen.
Table 14 Wireless > General: No Security
LABEL
DESCRIPTION
Security Level
Choose No Security to allow all wireless connections without data encryption or
authentication.
5.2.2 Basic (WEP Encryption)
WEP encryption scrambles the data transmitted between the wireless stations and the access points
(AP) to keep network communications private. Both the wireless stations and the access points
must use the same WEP key.
Note: WEP is extremely insecure. Its encryption can be broken by an attacker, using
widely-available software. It is strongly recommended that you use a more
effective security mechanism. Use the strongest security mechanism that all the
wireless devices in your network support. For example, use WPA-PSK or WPA2-PSK
if all your wireless devices support it, or use WPA or WPA2 if your wireless devices
support it and you have a RADIUS server. If your wireless devices support nothing
stronger than WEP, use the highest encryption level available.