eir F1000 Modem User’s Guide
Table 8 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL over ATM - Bridge
Mode) (continued)
Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
4.3 The 3G Backup Screen
The USB ports (at the left side panel of the Device) allow you to attach a 3G dongle to wirelessly
connect to a 3G network for Internet access. You can have the Device use the 3G WAN connection
as a backup. Disconnect the DSL and Ethernet WAN ports to use the 3G dongle as your primary
WAN connection. The Device automatically uses a wired WAN connection when available.
Note: This Device supports connecting one 3G dongle at a time.
Figure 27 Internet Access Application: 3G WAN
Use this screen to configure your 3G settings. Click Network Setting > Broadband > 3G
Backup.
To Next Page
Loading...
