eir F1000 Modem User’s Guide
Note: The actual data rate you obtain varies depending the 3G card you use, the signal
strength to the service provider’s base station, and so on.
Figure 28 Network Setting > Broadband > 3G Backup
The following table describes the labels in this screen.
Table 9 Network Setting > Broadband > 3G Backup
Select Enable to have the Device use the 3G connection as your WAN or a backup when the
wired WAN connection fails.
Select Enable if you want the Device to ping check the connection status of your WAN. You
can configure the frequency of the ping check and number of consecutive failures before
triggering 3G backup.
Enter the frequency of the ping check in this field.
Enter how many consecutive failures are required before 3G backup is triggered.
Select this to have the Device ping the WAN interface’s default gateway IP address.
Select this to have the Device ping the particular host name or IP address you typed in this
field.
This field displays the manufacturer and model name of your 3G card if you inserted one in
the Device. Otherwise, it displays N/A.
To Next Page
Loading...
