eir F1000 Modem User’s Guide
The following table describes the labels in this screen.
Table 21 Network Setting > Wireless > WPS
Select Enable to activate WPS on the Device.
Use this section to set up a WPS wireless network using Push Button Configuration (PBC).
Click this button to add another WPS-enabled wireless device (within wireless range of the
Device) to your wireless network. This button may either be a physical button on the
outside of device, or a menu button similar to the Connect button on this screen.
Note: You must press the other wireless device’s WPS button within two minutes of pressing
this button.
Use this section to set up a WPS wireless network by entering the PIN of the client into the
Device.
Enter the PIN of the device that you are setting up a WPS connection with and click
Register to authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the device’s
settings.
Note: You must also activate WPS on that device within two minutes to have it present its PIN
to the Device.
Use this section to set up a WPS wireless network by entering the PIN of the Device into the
client.
The default WPS status is configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the Device.
The PIN (Personal Identification Number) of the Device is shown here. Enter this PIN in the
configuration utility of the device you want to connect to using WPS.
The PIN is not necessary when you use WPS push-button method.
Click the Generate New PIN Number button to have the Device create a new PIN.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
5.6 The WMM Screen
Use this screen to enable Wi-Fi MultiMedia (WMM) and WMM Power Save in wireless networks for
multimedia applications.
Click Network Setting > Wireless > WMM. The following screen displays.
Figure 42 Network Setting > Wireless > WMM
To Next Page
Loading...
