eir F1000 Modem User’s Guide
Remote Management
28.1 Overview
Remote management controls through which interface(s), which services can access the Device.
Note: The Device is managed using the Web Configurator.
28.2 The Remote MGMT Screen
Use this screen to configure through which interface(s), which services can access the Device. You
can also specify the port numbers the services must use to connect to the Device. Click
Maintenance > Remote MGMT to open the following screen.
Figure 147 Maintenance > Remote MGMT
The following table describes the fields in this screen.
Table 114 Maintenance > Remote MGMT
WAN Interface
used for
services
Select Any WAN to have the Device automatically activate the remote management service
when any WAN connection is up.
Select Multi WAN and then select one or more WAN connections to have the Device
activate the remote management service when the selected WAN connections are up.
This is the service you may use to access the Device.
Select the Enable check box for the corresponding services that you want to allow access to
the Device from the LAN/WLAN.
Select the Enable check box for the corresponding services that you want to allow access to
the Device from the WAN.
To Next Page
Loading...
