eir F1000 Modem User’s Guide
Table 79 Security > Firewall > Access Control (continued)
This displays the name of the rule.
This displays the source IP addresses to which this rule applies. Please note that a blank
source address is equivalent to Any.
This displays the destination IP addresses to which this rule applies. Please note that a
blank destination address is equivalent to Any.
This displays the transport layer protocol that defines the service and the direction of traffic
to which this rule applies.
This field displays whether the rule silently discards packets (DROP), discards packets and
sends a TCP reset packet or an ICMP destination-unreachable message to the sender
(REJECT) or allows the passage of packets (ACCEPT).
Click the Edit icon to edit the rule.
Click the Delete icon to delete an existing rule. Note that subsequent rules move up by one
when you take this action.
Click the Move To icon to change the order of the rule. Enter the number in the # field.
13.4.1 Add/Edit an ACL Rule
Click Add new ACL rule or the Edit icon next to an existing ACL rule in the Access Control
screen. The following screen displays.
Figure 113 Access Control: Add/Edit
To Next Page
Loading...
