eir F1000 Modem User’s Guide
Table 6 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued)
Select Enable and enter a DSCP (DiffServ Code Point) value to have the Device add it in the
packets sent by this WAN interface.
Enter the MTU (Maximum Transfer Unit) size for this traffic.
Click Apply to save your changes back to the Device.
Click Cancel to exit this screen without saving.
4.2.1.2 Bridge Mode
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon
next to the connection you want to configure. Select Bridge as the encapsulation mode. The screen
varies depending on the interface type you select.
If you select ADSL/VDSL over PTM as the interface type, the following screen appears.
Figure 25 Network Setting > Broadband > Add New WAN Interface/Edit (Bridge Mode )
The following table describes the fields in this screen.
Table 7 Network Setting > Broadband > Add New WAN Interface/Edit (Bridge Mode)
Select this to activate the WAN configuration settings.
Enter a service name of the connection.
Select ADSL/VDSL over PTM as the interface that you want to configure. The Device uses
the VDSL technology for data transmission over the DSL port.
Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP’s DHCP server directly. If you
select Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and
NAT on traffic from the selected LAN port(s).
This section is available only when you select ADSL/VDSL over PTM in the Type field.
To Next Page
Loading...
