eir F1000 Modem User’s Guide
Table 41 Network Setting > Routing >Policy Forwarding (continued)
This is the WAN interface through which the traffic is routed.
Click the Edit icon to edit this policy.
Click the Delete icon to remove a policy from the Device. A window displays asking you to
confirm that you want to delete the policy.
7.4.1 Add/Edit Policy Forwarding
Click Add new Policy Forward Rule in the Policy Forwarding screen or click the Edit icon next
to a policy. Use this screen to configure the required information for a policy route.
Figure 71 Policy Forwarding: Add/Edit
The following table describes the labels in this screen.
Table 42 Policy Forwarding: Add/Edit
Enter a descriptive name of up to 8 printable English keyboard characters, not including
spaces.
Enter the source IP address.
Enter the source subnet mask address.
Select the transport layer protocol (TCP or UDP).
Enter the source port number.
Enter the source MAC address.
Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the Broadband screens.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
To Next Page
Loading...
