eir F1000 Modem User’s Guide
Chapter 9 Network Address Translation (NAT)
The following table describes the labels in this screen.
Table 56 Network Setting > NAT > Applications
Click this to add a new NAT application rule.
This field shows the type of application that the service forwards.
This field shows the WAN interface through which the service is forwarded.
This field displays the destination IP address for the service.
Click the Delete icon to delete the rule.
9.3.1 Add New Application
This screen lets you create new NAT application rules. Click Add new application in the
Applications screen to open the following screen.
Figure 85 Applications: Add
The following table describes the labels in this screen.
Table 57 Applications: Add
Select the WAN interface that you want to apply this NAT rule to.
Enter the inside IP address of the application here.
Select the category of the application from the drop-down list box.
Select a service from the drop-down list box and the Device automatically configures the
protocol, start, end, and map port number that define the service.
Click this to display the configuration of the service that you have chosen in Application
Fowarded.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
To Next Page
Loading...
