eir F1000 Modem User’s Guide
4.5.1 Edit 802.1X Settings
Use this screen to edit 802.1X authentication settings. Click the Edit icon next to the rule you want
to edit. The screen shown next appears.
Figure 31 Network Setting > Broadband > 802.1x: Edit
The following table describes the labels in this screen.
Table 12 Network Setting > Broadband > 802.1x: Edit
This field allows you to activate/deactivate the authentication.
Select this to enable the authentication. Clear this to disable this authentication without
having to delete the entry.
Select an interface to which the authentication applies.
Enter the EAP identity of the authentication.
This is the EAP method used for this authentication.
Enable
Bidirectional
Authentication
Select this to allow bidirectional authentication.
Select the certificate you want to assign to the authentication. You need to import the
certificate in the Security > Certificates > Local Certificates screen.
Select the Trusted CA you want to assign to the authentication. You need to import the
certificate in the Security > Certificates > Trusted CA screen.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
4.6 Technical Reference
The following section contains additional technical information about the Device features described
in this chapter.
To Next Page
Loading...
