eir F1000 Modem User’s Guide
Chapter 8 Quality of Service (QoS)
The following table describes the labels in this screen.
Table 45 Network Setting > QoS > Queue Setup
Click this button to create a new queue entry.
This is the index number of the entry.
This field displays whether the queue is active or not. A yellow bulb signifies that this queue
is active. A gray bulb signifies that this queue is not active. Click the bulb to enable/disable
this queue.
This shows the descriptive name of this queue.
This shows the name of the Device’s interface through which traffic in this queue passes.
This shows the priority of this queue.
This shows the weight of this queue.
This shows the queue management algorithm used for this queue.
Queue management algorithms determine how the Device should handle packets when it
receives too many (network congestion).
This shows the maximum transmission rate allowed for traffic on this queue.
Click the Edit icon to edit the queue.
Click the Delete icon to delete an existing queue. Note that subsequent rules move up by
one when you take this action.
8.4.1 Adding a QoS Queue
Click Add new Queue or the edit icon in the Queue Setup screen to configure a queue.
Figure 75 Queue Setup: Add
The following table describes the labels in this screen.
Table 46 Queue Setup: Add
Select to enable or disable this queue.
Enter the descriptive name of this queue.
Select the interface to which this queue is applied.
This field is read-only if you are editing the queue.
To Next Page
Loading...
