eir F1000 Modem User’s Guide
Chapter 8 Quality of Service (QoS)
Table 48 Class Setup: Add/Edit (continued)
Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
8.6 The QoS Policer Setup Screen
Use this screen to configure QoS policers that allow you to limit the transmission rate of incoming
traffic. Click Network Setting > QoS > Policer Setup. The screen appears as shown.
Figure 78 Network Setting > QoS > Policer Setup
The following table describes the labels in this screen.
Table 49 Network Setting > QoS > Policer Setup
Click this to create a new entry.
This is the index number of the entry.
This field displays whether the policer is active or not. A yellow bulb signifies that
this policer
is active. A gray bulb signifies that this policer is not active. Click the bulb to enable/ disable
the policer.
This field displays the descriptive name of this policer.
This field displays the name of a QoS classifier this policer uses.
This field displays the type of QoS metering algorithm used in this policer.
These are the rates and burst sizes against which the policer checks the traffic of the
member QoS classes.
This shows the how the policer has the Device treat different types of traffic belonging to
the policer’s member QoS classes.
Click the Edit icon to edit the policer.
Click the Delete icon to delete an existing policer. Note that subsequent rules move up by
one when you take this action.
To Next Page
Loading...
