ZyXEL Communications eir F1000 - The Wake on LAN Screen

Chapter 6 Home Networking
123
eir F1000 Modem User’s Guide
The following table describes the labels in this screen.
Table 35 Network Setting > Home Networking > LAN VLAN
LABEL
DESCRIPTION
Lan Port
These represent the Device’s LAN ports.
Tag Operation
Select what you want the Device to do to the IEEE 802.1q VLAN ID and priority tags of
downstream traffic before sending it out through this LAN port.
• Unchange - Don’t do anything to the traffic’s VLAN ID and priority tags.
• Add - Add VLAN ID and priority tags to untagged traffic.
• Remove - Delete one tag from tagged traffic. If the frame has double tags, this removes
the outer tag. This does not affect untagged traffic.
• Remark - Change the value of the outer VLAN ID and priority tags.
802.1P Mark
Use this option to set what to do for the IEEE 802.1p priority tags when you add or remark
the tags for a LAN port’s downstream traffic. Either select Unchange to not modify the
traffic’s priority tags or select an priority from 0 to 7 to use. The larger the number, the
higher the priority.
VLAN ID
If you will add or remark tags for this LAN port’s downstream traffic, specify the VLAN ID
(from 0 to 4094) to use here.
Apply
Click Apply to save your changes.
Cancel
Click Cancel to exit this screen without saving.
6.11 The Wake on LAN Screen
Use this screen to turn on a device on the LAN network. To use this feature, the remote device must
also support Wake On LAN.
You need to know the MAC address of the LAN device. It may be on a label on the device or in its
documentation.
Click Network Setting > Home Networking > Wake on Lan to open this screen.
Figure 63 Network Setting > Home Networking > Wake on Lan
The following table describes the labels in this screen.
Table 36 Network Setting > Home Networking > Wake on Lan
LABEL
DESCRIPTION
Wake by
Address
Select Manual and enter the IP address or MAC address of the device to turn it on remotely.
The drop-down list also lists the IP addresses that can be found in the Device’s ARP table.
Select an IP address and it will then automatically update the IP address and MAC address
in the following fields.
IP Address
Enter the IPv4 IP address of the device to turn it on.
MAC Address
Enter the MAC address of the device to turn it on. A MAC address consists of six
hexadecimal character pairs.
Wake up
Click this to send a wake up packet to wake up the specified device.