eir F1000 Modem User’s Guide
Note: This screen is available only when you configure an ATM layer-2 interface.
Figure 171 Maintenance > Diagnostic > OAM Ping
The following table describes the fields in this screen.
Table 127 Maintenance > Diagnostic > OAM Ping
Select a PVC on which you want to perform the loopback test.
Press this to perform an OAM F4 segment loopback test.
Press this to perform an OAM F4 end-to-end loopback test.
Press this to perform an OAM F5 segment loopback test.
Press this to perform an OAM F5 end-to-end loopback test.
36.6 WAN Diagnostics Tests
Click Maintenance > Diagnostic > WAN Diagnostics Tests to open the screen shown next. Use
this screen to perform a test on the current WAN connection by clicking the Wan Connection Test
button. The test result then displays in the text box.
Figure 172 Maintenance > Diagnostic > WAN Diagnostics Tests
To Next Page
Loading...
