eir F1000 Modem User’s Guide
Table 20 Wireless > MAC Authentication (continued)
Click this if you want to add a new MAC address entry to the MAC filter list below.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the
Device in these address fields. Enter the MAC addresses in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
This is the index number of the entry.
This is the MAC addresses of the wireless devices that are allowed or denied access to the
Device.
Click the Delete icon to delete the entry.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
5.5 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See Section 5.10.9.3 on page 98 for more information about WPS.
Note: The Device applies the security settings of the SSID1 profile (see Section 5.2 on
page 70). If you want to use the WPS feature, make sure you have set the security
mode of SSID1 to WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Figure 41 Network Setting > Wireless > WPS
To Next Page
Loading...
