eir F1000 Modem User’s Guide
Chapter 9 Network Address Translation (NAT)
Table 54 Network Setting > NAT > Port Forwarding (continued)
This shows the IP protocol supported by this virtual server, whether it is TCP, UDP, or TCP/
UDP.
Click the Edit icon to edit this rule.
Click the Delete icon to delete an existing rule.
9.2.1 Add/Edit Port Forwarding
Click Add new rule in the Port Forwarding screen or click the Edit icon next to an existing rule to
open the following screen.
Figure 83 Port Forwarding: Add/Edit
The following table describes the labels in this screen.
Table 55 Port Forwarding: Add/Edit
Clear the checkbox to disable the rule. Select the check box to enable it.
Enter a name to identify this rule using keyboard characters (A-Z, a-z, 1-2 and so on).
Select the WAN interface through which the service is forwarded.
You must have already configured a WAN connection with NAT enabled.
Enter the WAN IP address for which the incoming service is destined. If the packet’s
destination IP address doesn’t match the one specified here, the port forwarding rule will
not be applied.
To Next Page
Loading...
