eir F1000 Modem User’s Guide
Your Device allows you to configure up to four 64-bit or 128-bit WEP keys but only one key can be
enabled at any one time.
In order to configure and enable WEP encryption, click Network Setting > Wireless to display the
General screen, then select Basic as the security level.
Figure 35 Wireless > General: Basic (WEP)
The following table describes the labels in this screen.
Table 15 Wireless > General: Basic (WEP)
Select Basic to enable WEP data encryption.
Generate
password
automatically
Select this option to have the Device automatically generate a password. The password field
will not be configurable when you select this option.
The password (WEP key) is used to encrypt data. Both the Device and the wireless stations
must use the same password (WEP key) for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
This field is available when the Generate password automatically checkbox is cleared.
Select password unmask to show your entered password in plain text.
Select 64-bits or 128-bits.
This dictates the length of the security key that the network is going to use.
Click Notes: to show more information about the WEP key.
To Next Page
Loading...
