eir F1000 Modem User’s Guide
managed objects. SNMP allows a manager and agents to communicate for the purpose of accessing
these objects.
SNMP itself is a simple request/response protocol based on the manager/agent model. The
manager issues a request and the agent returns responses using the following protocol operations:
• Get - Allows the manager to retrieve an object variable from the agent.
• GetNext - Allows the manager to retrieve the next object variable from a table or list within an
agent. In SNMPv1, when a manager wants to retrieve all elements of a table from an agent, it
initiates a Get operation, followed by a series of GetNext operations.
• Set - Allows the manager to set values for object variables within an agent.
• Trap - Used by the agent to inform the manager of some events.
Click Maintenance > SNMP to open the following screen. Use this screen to configure the Device
SNMP settings.
Figure 152 Maintenance > SNMP
The following table describes the fields in this screen.
Table 118 Maintenance > SNMP
Select Enable to let the Device act as an SNMP agent, which allows a manager station
to manage and monitor the Device through the network. Select Disable to turn this
feature off.
Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station.
Enter the Set community, which is the password for incoming Set requests from the
management station.
Enter the SNMP system name.
Enter the SNMP system location.
Enter the SNMP system contact.
Type the IP address of the station to send your SNMP traps to.
Click this to save your changes back to the Device.
Click this to restore your previously saved settings.
To Next Page
Loading...
