eir F1000 Modem User’s Guide
Click Network Setting > Wireless > WDS. The following screen displays.
Figure 43 Network Setting > Wireless > WDS
The following table describes the labels in this screen.
Table 23 Network Setting > Wireless > WDS
Select the operating mode for your Device.
• Access Point - The Device functions as a bridge and access point simultaneously.
• Wireless Bridge - The Device acts as a wireless network bridge and establishes
wireless links with other APs. In this mode, clients cannot connect to the Device
wirelessly.
This field is available only when you set operating mode to Access Point.
Select Enabled to turn on WDS and enter the peer device’s MAC address manually in the
table below. Select Disable to turn off WDS.
Remote Bridge
MAC Address
You can enter the MAC address of the peer device by clicking the Edit icon under Modify.
This is the index number of the entry.
This shows the MAC address of the peer device.
You can connect to up to 4 peer devices.
Click the Edit icon and type the MAC address of the peer device in a valid MAC address
format (six hexadecimal character pairs, for example 12:34:56:78:9a:bc).
Click the Delete icon to remove this entry.
Click the Scan icon to search and display the available APs within range.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
To Next Page
Loading...
