Chapter 10 Control Panel
Cloud Storage User’s Guide
107
PPPoE
Point-to-Point Protocol over Ethernet (PPPoE) allows the NAS to establish a direct Internet
connection if you do not have a router. PPPoE is a dial-up connection. You need a username and
password from your Internet Service Provider (ISP) to set up the connection.
10.4 TCP/IP Screens
Use the TCP/IP screens to have the NAS use a dynamic or static IP address, subnet mask, default
gateway, PPPoE and DNS servers, and to test the network connection.
10.4.1 Configuring General TCP/IP Settings
Click Control Panel > Network > TCP/IP > General Settings in the navigation panel to open
the following screen. This screen allows you to configure the default gateway and DNS server.
Note: If you change the NAS’s IP address, you need to log in again after you apply
changes.
Figure 60 Control Panel > Network > TCP/IP > General Settings
To Next Page
Loading...
