Chapter 27 Protect
Cloud Storage User’s Guide
322
Figure 200 Protect > Backup
The following table describes the labels in this screen.
27.3.1 Backup: Step 1
Use this screen to specify the job information and back up type.
Click Add Job in the Protect > Backup screen to open the following:
Table 128 Protect > Backup
LABEL DESCRIPTION
Backup
Add Job Click this to create and customize a backup job.
Edit Job Select a backup job in the list and click this to make some changes to it.
Delete Selected
Job(s)
Select a backup job in the list and click this to delete it.
Execute Job Now Select a backup job in the list and click this to run the backup job immediately.
Restore Archive Select a backup job in the list and click this to restore the file(s) included in that backup
job to the NAS.
This applies to Archive backups only. Refer to Section 27.3.8 on page 330 to see the
screens.
Abort Job Select a backup job in the list and click this to stop the process if the backup job is
currently active.
Activate Job Enable the selected backup job.
Inactivate Job Disable the selected backup job.
Status This shows the current state of the backup job.
• Waiting means the backup job is not active but is scheduled to run at some time.
• Running indicates that the NAS is currently doing the backup job. When the backup
job is running, you can also see a progress bar.
Job Name This identifies the backup job.
Job Description This is a short description of the backup job.
Backup Info This lists down the backup job details: type, source and target. Refer to Section 27.3.1
on page 322 and Section 27.3.2 on page 323.
Scheduler Info This shows the backup schedule, including the frequency, the time it was last run in
(and whether or not it succeeded), and when it is scheduled to run again. The times use
yyyy-mm-dd hh:mm:ss format.
Refer to Section 27.3.4 on page 326.
To Next Page
Loading...
