Chapter 10 Control Panel
Cloud Storage User’s Guide
108
The following table describes the labels in this screen
10.4.2 Configuring Network Interface
Use the Network Interface screen to edit the IPv4 or IPv6 settings of LAN 1 and LAN 2, set up
port trunking, and configure PPPoE settings. Click Control Panel > Network > TCP/IP >
Network Interface in the navigation panel to open the following screen.
Figure 61 Control Panel > Network > TCP/IP > Network Interface
Table 39 Control Panel > Network > TCP/IP > General Settings
LABEL DESCRIPTION
Default Gateway Select the LAN interface to use as the default gateway.
DNS Server DNS (Domain Name System) is for mapping a domain name to its corresponding IP
address and vice versa. If you have the IP address(es) of the DNS server(s), enter
them.
Automatically Select the option to have the NAS get a DNS server address automatically.
Manually Select this option to choose a static DNS server address. Type the DNS server IP
address(es) into the fields below.
Primary DNS
Server
Type a primary DNS server IP address.
Secondary DNS
Server
Type a secondary DNS server IP address.
Apply Click this to save your TCP/IP configurations. After you click Apply, the NAS restarts.
Wait until you see the Login screen or until the NAS fully boots and then use the NAS
Starter Utility to rediscover it.
Reset Click this to restore your previously saved settings.
To Next Page
Loading...
