Chapter 17 Applications
Cloud Storage User’s Guide
226
Figure 126 Applications > Download Service > Preferences > P2P download
The following table describes the labels in this screen.
Table 75 Applications > Download Service > Preferences > P2P download
LABEL DESCRIPTION
Port Number Assign a port number for P2P downloads. You can select a number from 2 to 65536. It
is recommended to use a port number greater than 1025.
DHT Select Enable or Disable to use Distributed Hash Table (DHT) or not.
Note: When you use DHT, the NAS will also attempt to open a UDP port one number
smaller than the P2P download port number. So if the P2P download port number
is 9090, the NAS uses UDP port 9089.
Max. download rate You may need to limit the bandwidth the NAS uses for P2P downloads if your network’s
other Internet applications are not getting enough downstream bandwidth. 0 has the
NAS impose no restriction.
Max. upload rate You may need to limit the bandwidth the NAS uses to share files through P2P download
if your network’s other Internet applications are not getting enough upstream
bandwidth. 0 has the NAS impose no restriction.
If you do not allow any uploads, (for example, you set a limit of 1 KB/s) you will not
have a good standing in the P2P download community.
Note: The settings for maximum download/upload rates would not affect peers accessing
the NAS from the same LAN.
Maximum Number
of Active Torrents
Specify how many simultaneous P2P downloads are allowed on the NAS. You can enter
a number from 1 to 10.
Maximum Number
of Seeding Jobs
Specify how many simultaneous seeds are allowed on the NAS. Enter a number from 1
to 10. This value cannot exceed the one you configured in the Maximum Number of
Active Torrents field.
Maximum Number
of Active
Connections
Specify how many active connections are allowed on the NAS. Enter a number from 1 to
500. This specifies the number of computers that can connect to the NAS to download
files being shared by the NAS.
To Next Page
Loading...
