Chapter 27 Protect
Cloud Storage User’s Guide
333
Figure 210 Protect > Restore: Step 1
The following table describes the labels in this screen.
Table 138 Protect > Restore: Step 1
LABEL DESCRIPTION
Step 1. Select
Restore Source
Select a previous archive backup that you want to restore to the NAS.
Select Remote NAS if the file is in another NAS in the network that you used for your
backup. Fill in the fields below when you choose this option.
Select Internal or External Volume if you want to use another volume in the NAS or an
attached USB hard disk for your backup. Click Browse to select the backup file.
IP Address Enter the address of the NAS you want to use.
User Enter the username you use to access the NAS.
Password Enter the password of your NAS account.
Share Name Enter the name of the share you want to use.
Test Connection Click this to test your connection to the remote NAS that you have specified in the fields
above.
Browse Click this to select where the previous backup that you want to restore is located.
• Volume - Select a volume from the list.
• Current Location - This is the location of the selected folder.
• Type - This identifies the item as a file or folder.
• Name - This is the name of the folder/file.
Click Apply to save your settings and Cancel to close the screen.
Next Click this to go to the next screen.
To Next Page
Loading...
