Chapter 7 MBSSID and SSID
ZyXEL NWA-3100 User’s Guide
103
QoS Select the Quality of Service priority for this BSS’s traffic.
• In the pre-configured VoIP_SSID profile, the QoS setting is VoIP. This is
not user-configurable. The VoIP setting is available only on the
VoIP_SSID profile, and provides the highest level of QoS.
• If you select WMM from the QoS list, the priority of a data packet depends
on the packet’s VLAN or DSCP header. See Section 5.3.1 on page 69 for
more information on WMM and WMM priorities. If a packet has no WMM
value assigned to it, it is assigned the default priority.
• If you select ATC from the QoS list, the ZyXEL Device automatically
assigns priority based on packet size. See Section 5.3.2 on page 69 for
more information on ATC.
• If you select ATC+WMM from the QoS list, the ZyXEL Device uses WMM
on the wireless network and ATC on the wired network. See Section 5.3.3
on page 70 for more information on ATC+WMM.
• If you select WMM_VOICE, WMM_VIDEO, WMM_BEST_EFFORT or
WMM_BACKGROUND, the ZyXEL Device applies that QoS setting to all
of that SSID’s traffic.
• If you select NONE, the ZyXEL Device applies no priority to traffic on this
SSID.
Note: When you configure an SSID profile’s QoS settings,
the ZyXEL Device applies the same QoS setting to all
of the profile’s traffic.
L2 Isolation Select Enable from the drop down list box to activate layer-2 isolation.
Enable MAC Filtering
Select Enable from the drop down list box to activate MAC address filtering.
Intra-BSS Traffic
blocking
Select Enable from the drop-down list box to prevent wireless clients in this
profile’s BSS from communicating with one another.
Apply Click Apply to save your changes.
Reset Click Reset to begin configuring this screen afresh.
Table 30 Configuring SSID
LABEL DESCRIPTION
To Next Page
Loading...
