Chapter 13 Log Screens
ZyXEL NWA-3100 User’s Guide
156
Use the sys logs save command to store the settings in the ZyXEL Device (you must do
this in order to record logs).
13.4.2 Displaying Logs
Use the sys logs display command to show all of the logs in the ZyXEL Device’s log.
Use the sys logs category display command to show the log settings for all of the
log categories.
Use the sys logs display [log category] command to show the logs in an
individual ZyXEL Device log category.
Use the sys logs clear command to erase all of the ZyXEL Device’s logs.
13.5 Log Command Example
This example shows how to set the ZyXEL Device to record the error logs and alerts and then
view the results.
mten 0, 1
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to record only
alerts for that category, and
3 to record both logs and alerts for that category.
Table 57 Log Categories and Available Settings
LOG CATEGORIES AVAILABLE PARAMETERS
ras> sys logs load
ras> sys logs category error 3
ras> sys logs save
ras> sys logs display access
#. time source destination notes message
0 | 11/11/2002 15:10:12 | 172.22.3.80:137 | 172.22.255.255:137 | ACCESS BLOCK
To Next Page
Loading...
