Chapter 15 Maintenance
ZyXEL NWA-3100 User’s Guide
182
After you see a “restore configuration successful” screen, you must then wait one minute
before logging into the ZyXEL Device again.
Figure 123 Configuration Upload Successful
The ZyXEL Device automatically restarts in this time causing a temporary network
disconnect. In some operating systems, you may see the following icon on your desktop.
Figure 124 Network Temporarily Disconnected
If you uploaded the default configuration file you may need to change the IP address of your
computer to be in the same subnet as that of the default ZyXEL Device IP address
(192.168.1.2). See your Quick Start Guide for details on how to set up your computer’s IP
address.
If the upload was not successful, the following screen will appear. Click Return to go back to
the Configuration screen.
Figure 125 Configuration Upload Error
15.6.3 Back to Factory Defaults
Pressing the Reset button in this section clears all user-entered configuration information and
returns the ZyXEL Device to its factory defaults as shown on the screen. The following
warning screen will appear.
To Next Page
Loading...
