Chapter 6 Wireless Security Configuration
ZyXEL NWA-3100 User’s Guide
89
Figure 49 Security: 802.1x Only
The following table describes the labels in this screen.
6.9.3 Security: 802.1x Static 64-bit, 802.1x Static 128-bit
Select 802.1x Static 64 or 802.1x Static 128 in the Security Mode field to display the
following screen.
Table 22 Security: 802.1x Only
LABEL DESCRIPTION
Name Type a name to identify this security profile.
Security Mode Choose 802.1x Only in this field.
ReAuthentication
Timer
Specify how often wireless stations have to resend user names and passwords in
order to stay connected.
Enter a time interval between 10 and 9999 seconds. The default time interval is
1800 seconds (30 minutes).
Note: If wireless station authentication is done using a
RADIUS server, the reauthentication timer on the
RADIUS server has priority.
Idle Timeout The ZyXEL Device automatically disconnects a wireless station from the wireless
network after a period of inactivity. The wireless station needs to send the
username and password again before it can use the wireless network again. Some
wireless clients may prompt users for a username and password; other clients
may use saved login credentials. In either case, there is usually a short delay while
the wireless client logs in to the wireless network again.
This value is usually smaller when the wireless network is keeping track of how
much time each wireless station is connected to the wireless network (for
example, using an authentication server). If the wireless network is not keeping
track of this information, you can usually set this value higher to reduce the
number of delays caused by logging in again.
The default time interval is 3600 seconds (or 1 hour).
Apply Click Apply to save your changes.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
