ZyXEL NWA-3100 User’s Guide
187
CHAPTER 16
Introducing the SMT
This chapter describes how to access the SMT and provides an overview of its menus.
16.1 Connect to your ZyXEL Device Using Telnet
The following procedure details how to telnet into your ZyXEL Device.
1 In Windows, click Start (usually in the bottom left corner), Run and then type “telnet
192.168.1.2” (the default IP address) and click OK.
2 For your first login, enter the default password “1234”. As you type the password, the
screen displays an asterisk “*” for each character you type.
Figure 128 Login Screen
3 After entering the password you will see the main menu.
Please note that if there is no activity for longer than five minutes (default timeout period)
after you log in, your ZyXEL Device will automatically log you out. You will then have to
telnet into the ZyXEL Device again. You can use the web configurator or the CI commands to
change the inactivity time out period.
16.2 Changing the System Password
Change the ZyXEL Device’s default password by following the steps shown next.
1 From the main menu, enter 23 to display Menu 23 – System Password as shown next.
2 Type your existing system password in the Old Password field, and press [ENTER].
Figure 129 Menu 23 System Password
Password : xxxx
Menu 23 - System Password
Old Password= ?
New Password= ?
Retype to confirm= ?
Enter here to CONFIRM or ESC to CANCEL:
To Next Page
Loading...
