Chapter 21 System Information and Diagnosis
ZyXEL NWA-3100 User’s Guide
202
21.2.2 Console Port Speed
You can set up different port speeds for the console port through Menu 24.2.2 – System
Maintenance – Console Port Speed. Your ZyXEL Device supports 9600 (default), 19200,
38400, 57600 and 115200 bps console port speeds. Press [SPACE BAR] and then [ENTER] to
select the desired speed in menu 24.2.2, as shown in the following figure.
Figure 140 Menu 24.2.2 System Maintenance: Change Console Port Speed
After you changed your ZyXEL Device’s console port speed, you must also make the same
change to the console port speed parameter of your communication software.
21.3 Log and Trace
Your ZyXEL Device provides error logs and trace records that are stored locally.
21.3.1 Viewing Error Log
The first place you should look for clues when something goes wrong is the error log. Follow
the procedures to view the local error/trace log:
1 Type 24 in the main menu to display Menu 24 – System Maintenance.
2 From menu 24, type 3 to display Menu 24.3 – System Maintenance – Log and Trace.
Country Code Refers to the country code of the firmware.
LAN
Ethernet Address Refers to the Ethernet MAC (Media Access Control) of your ZyXEL Device.
IP Address This is the IP address of the ZyXEL Device in dotted decimal notation.
IP Mask This shows the subnet mask of the ZyXEL Device.
DHCP This field shows the DHCP setting of the ZyXEL Device.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC
to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
Table 74 Menu 24.2.1 System Maintenance: Information
FIELD DESCRIPTION
Menu 24.2.2 – System Maintenance – Change Console Port Speed
Console Port Speed: 9600
Press ENTER to Confirm or ESC to Cancel:
To Next Page
Loading...
