Chapter 4 System Screens
ZyXEL NWA-3100 User’s Guide
65
4.4 Configuring Time Setting
To change your ZyXEL Device’s time and date, click SYSTEM > Time Setting. The screen
appears as shown. Use this screen to configure the ZyXEL Device’s time based on your local
time zone.
Figure 34 Time Setting
The following table describes the labels in this screen.
Table 7 Time Setting
LABEL DESCRIPTION
Time Protocol Select the time service protocol that your time server sends when you turn on
the ZyXEL Device. Not all time servers support all protocols, so you may have
to check with your ISP/network administrator or use trial and error to find a
protocol that works.
The main difference between them is the format.
Daytime (RFC 867) format is day/month/year/time zone of the server.
Time (RFC 868) format displays a 4-byte integer giving the total number of
seconds since 1970/1/1 at 0:0:0.
The default, NTP (RFC 1305), is similar to Time (RFC 868).
Select None to enter the time and date manually.
Time Server Address Enter the IP address or the URL of your time server. Check with your ISP/
network administrator if you are unsure of this information.
Current Time
(hh:mm:ss)
This field displays the time of your ZyXEL Device.
Each time you reload this page, the ZyXEL Device synchronizes the time with
the time server.
New Time (hh:mm:ss) This field displays the last updated time from the time server.
When you select None in the Time Protocol field, enter the new time in this
field and then click Apply.
Current Date (yyyy/
mm/dd)
This field displays the date of your ZyXEL Device.
Each time you reload this page, the ZyXEL Device synchronizes the date with
the time server.
To Next Page
Loading...
