ZyXEL Communications NWA-3100 - Log Screens

ZyXEL NWA-3100 User’s Guide
151
CHAPTER 13
Log Screens
This chapter contains information about configuring general log settings and viewing the
ZyXEL Device’s logs. Refer to the appendix for example log message explanations.
13.1 Configuring View Log
The web configurator allows you to look at all of the ZyXEL Device’s logs in one location.
Click LOGS > View Log. Use the View Log screen to see the logs for the categories that you
selected in the Log Settings screen (see Figure 90 on page 152). Options include logs about
system maintenance, system errors and access control.
You can view logs and alert messages in this page. Once the log entries are all used, the log
will wrap around and the old logs will be deleted.
Click a column heading to sort the entries. A triangle indicates the direction of the sort order.
Figure 89 View Log
The following table describes the labels in this screen.
Table 52 View Log
LABEL DESCRIPTION
Display Select a log category from the drop down list box to display logs within the
selected category. To view all logs, select All Logs.
The number of categories shown in the drop down list box depends on the
selection in the Log Settings page.
Time This field displays the time the log was recorded.
Message This field states the reason for the log.
Source This field lists the source IP address and the port number of the incoming
packet.
Destination This field lists the destination IP address and the port number of the incoming
packet.