ZyXEL Communications NWA-3100 - Figure 10 Tutorial: Example MBSSID Setup; Table 2 Tutorial: Example Information; Change the Operating Mode

Chapter 3 Tutorial
ZyXEL NWA-3100 User’s Guide
44
Figure 10 Tutorial: Example MBSSID Setup
The standard network (SSID04) has access to all resources. The VoIP network (VoIP_SSID)
has access to all resources and a high Quality of Service (QoS) setting (see Section 5.3 on page
69 for information on QoS). The guest network (Guest_SSID) has access to the Internet and
the network printer only, and a low QoS setting.
To configure these settings, you need to know the MAC (Media Access Control) addresses of
the devices you want to allow users of the guest network to access. The following table shows
the addresses used in this example.
3.1.1 Change the Operating Mode
Log in to the ZyXEL Device (see Section 2.1 on page 39). Click WIRELESS > Wireless. The
Wireless screen appears. In this example, the ZyXEL Device is set to Access Point operating
mode, and is currently using the SSID04 profile.
Table 2 Tutorial: Example Information
Network router (A) MAC address 00:AA:00:AA:00:AA
Network printer (B) MAC address AA:00:AA:00:AA:00