Chapter 15 Maintenance
ZyXEL NWA-3100 User’s Guide
176
15.2.1 System Statistics
Read-only information here includes port status, packet specific statistics and bridge link
status. Also provided are "system up time" and "poll interval(s)". The Poll Interval field is
configurable.
Figure 115 System Status: Show Statistics
The following table describes the labels in this screen.
Table 62 System Status: Show Statistics
LABEL DESCRIPTION
Port This is the Ethernet or wireless port.
Status This shows the port speed and duplex setting if you are using Ethernet
encapsulation for the Ethernet port. Ethernet port connections can be in half-
duplex or full-duplex mode. Full-duplex refers to a device's ability to send and
receive simultaneously, while half-duplex indicates that traffic can flow in only
one direction at a time. The Ethernet port must use the same speed or duplex
mode setting as the peer Ethernet port in order to connect.
This shows the transmission speed only for the wireless port.
TxPkts This is the number of transmitted packets on this port.
RxPkts This is the number of received packets on this port.
Collisions This is the number of collisions on this port.
Tx B/s This shows the transmission speed in bytes per second on this port.
Rx B/s This shows the reception speed in bytes per second on this port.
Up Time This is total amount of time the line has been up.
Bridge Link # This is the index number of the bridge connection.
Active This shows whether the bridge connection is activated or not.
Remote Bridge MAC
Address
This is the MAC address of the peer device in bridge mode.
To Next Page
Loading...
