ZyXEL Communications NWA-3100 - Configuring Layer-2 Isolation

Chapter 8 Other Wireless Configuration
ZyXEL NWA-3100 User’s Guide
106
Figure 59 Layer-2 Isolation Application
MAC addresses that are not listed in the Allow devices with these MAC addresses table are
blocked from communicating with the ZyXEL Device’s wireless clients except for broadcast
packets. Layer-2 isolation does not check the traffic between wireless clients that are
associated with the same AP. Intra-BSS Traffic allows wireless clients associated with the
same AP to communicate with each other.
8.2 Configuring Layer-2 Isolation
If layer-2 isolation is enabled, you need to know the MAC address of the wireless client, AP,
computer or router that you want to allow to communicate with the ZyXEL Device's wireless
clients.
To configure layer-2 isolation, click WIRELESS > Layer-2 Isolation. The screen appears as
shown next.