ZyXEL Communications NWA-3100 - Activate the Guest Profile; Figure 21 Tutorial: Guest Security: Updated; Figure 22 Tutorial: Layer 2 Isolation; Set up Layer 2 Isolation

Chapter 3 Tutorial
ZyXEL NWA-3100 User’s Guide
51
• Select WPA-PSK in the Security Mode field. WPA-PSK provides strong security that is
supported by most wireless clients. Even though your Guest_SSID clients do not have
access to sensitive information on the network, you should not leave the network without
security. An attacker could still cause damage to the network or intercept unsecured
communications.
• Enter the PSK you want to use in your network in the Pre Shared Key field. In this
example, the PSK is “ThisismyGuestWPApre-sharedkey”.
• Click Apply. The WIRELESS > Security screen displays. Ensure that the Profile Name
for entry 3 displays “Guest_Security” and that the Security Mode is WPA-PSK.
Figure 21 Tutorial: Guest Security: Updated
3.1.3.2 Set up Layer 2 Isolation
Configure layer 2 isolation to control the specific devices you want the users on your guest
network to access. Click WIRELESS > Layer-2 Isolation. The following screen appears.
Figure 22 Tutorial: Layer 2 Isolation
Enter the MAC addresses of the two network devices you want users on the guest network to
be able to access; the main network router (00:AA:00:AA:00:AA) and the network printer
(AA:00:AA:00:AA:00). Click Apply.
3.1.3.3 Activate the Guest Profile
You need to activate the Guest_SSID profile before it can be used. Click the Wireless tab. In
the Select SSID Profile table, select the check box for the Guest_SSID profile and click
Apply.