Chapter 15 System
NWA1000 Series User’s Guide
139
15.3.1 Pre-defined NTP Time Servers List
When you turn on the NWA1000 Series for the first time, the date and time start at 2003-01-01 00:00:00.
The NWA1000 Series then attempts to synchronize with one of the following pre-defined list of Network
Time Protocol (NTP) time servers.
The NWA1000 Series continues to use the following pre-defined list of NTP time servers if you do not
specify a time server or it cannot synchronize with the time server you specified.
When the NWA1000 Series uses the pre-defined list of NTP time servers, it randomly selects one server and
tries to synchronize with it. If the synchronization fails, then the NWA1000 Series goes through the rest of
the list in order from the first one tried until either it is successful or all the pre-defined NTP time servers
have been tried.
15.3.2 Time Server Synchronization
Click the Sync. Now button to get the time and date from the time server you specified in the Time
Server Address field.
When the Loading message appears, you may have to wait up to one minute.
Figure 85 Loading
The Current Time and Current Date fields will display the appropriate settings if the synchronization is
successful.
If the synchronization was not successful, a log displays in the View Log screen. Try re-configuring the
Date/Time screen.
To manually set the NWA1000 Series date and time:
1 Click System > Date/Time.
2 Select Manual under Time and Date Setup.
3 Enter the NWA1000 Series’s time in the New Time field.
4 Enter the NWA1000 Series’s date in the New Date field.
5 Under Time Zone Setup, select your Time Zone from the list.
6 As an option you can select the Enable Daylight Saving check box to adjust the NWA1000 Series clock
for daylight savings.
7 Click Apply.
Table 64 Default Time Servers
0.pool.ntp.org
1.pool.ntp.org
2.pool.ntp.org
To Next Page
Loading...
