ZyXEL Communications NWA1000 Series - NCC Discovery

Chapter 9 Network
NWA1000 Series User’s Guide
77
9.4 NCC Discovery
You can manage the NWA1000 Series through the Zyxel Nebula Control Center (NCC). Use this screen to
configure the proxy server settings if the NWA1000 Series is behind a proxy server.
To access this screen, click Configuration > Network > NCC Discovery.
Figure 46 Configuration > Network > NCC Discovery
Each field is described in the following table.
Apply Click Apply to save your changes back to the NWA1000 Series.
Reset Click Reset to return the screen to its last-saved settings.
Table 31 Configuration > Network > VLAN (continued)
LABEL DESCRIPTION
Table 32 Configuration > Network > NCC Discovery
LABEL DESCRIPTION
Enable Select this option to turn on NCC discovery on the NWA1000 Series. The NWA1000 Series
will try to discover the NCC and go into cloud mode when it is connected to the
Internet and has been registered in the NCC.
If NCC discovery is disabled, the NWA1000 Series will not discover the NCC and remain
in standalone mode.
Use Proxy to Access NCC If the NWA1000 Series is behind a proxy server, you need to select this option and
configure the proxy server settings so that the NWA1000 Series can access the NCC
through the proxy server.
Proxy Server Enter the IP address of the proxy server.
Proxy Port Enter the service port number used by the proxy server.
Authentication Select this option if the proxy server requires authentication before it grants access to
the NCC.
User Name Enter your proxy user name.
Password Enter your proxy password.
Apply Click Apply to save your changes back to the NWA1000 Series.
Reset Click Reset to return the screen to its last-saved settings.