NWA1000 Series User’s Guide
72
CHAPTER 9
Network
9.1 Overview
This chapter describes how you can configure the management IP address and VLAN settings of your
NWA1000 Series.
The Internet Protocol (IP) address identifies a device on a network. Every networking device (including
computers, servers, routers, printers, etc.) needs an IP address to communicate across the network.
These networking devices are also known as hosts.
Figure 41 IP Setup
The figure above illustrates one possible setup of your NWA1000 Series. The gateway IP address is
192.168.1.1 and the managed IP address of the NWA1000 Series is 192.168.1.2 (default), but if the
NWA1000 Series is assigned an IP address by a DHCP server, the default (192.168.1.2) will not be used.
The gateway and the NWA1000 Series must belong in the same IP subnet to be able to communicate
with each other.
9.1.1 What You Can Do in this Chapter
• The IP Setting screen (Section 9.2 on page 72) configures the NWA1000 Series’s LAN IP address.
• The VLAN screen (Section 9.3 on page 74) configures the NWA1000 Series’s VLAN settings.
• The NCC Discovery screen (Section 9.4 on page 77) configures the NWA1000 Series’s Nebula Control
Center (NCC) discovery settings.
9.2 IP Setting
Use this screen to configure the IP address for your NWA1000 Series. To access this screen, click
Configuration > Network > IP Setting.
To Next Page
Loading...
