Chapter 3 Hardware
NWA1000 Series User’s Guide
23
3.1.4 NWA1302-AC
By default, the LEDs automatically turn on when the NWA1302-AC is ready. If the Suppression On option
is selected in the LEDs > Suppression screen (see Section 19.2 on page 183) to turn off the LEDs, you can
press the LED ON button for one second to turn on the LEDs again. The LEDs will blink and turn off after
two minutes.
Figure 8 NWA1302-AC LEDs
The following table describes the LEDs.
Table 5 NWA1302-AC LEDs
LED COLOR STATUS DESCRIPTION
PWR/SYS Red Slow Blinking (On for 1
sec, Off for 1 sec)
The LED blinks orange and green alternatively when the
NWA1000 Series is booting up.
Green On
Green On The NWA1000 Series is ready for use.
Slow Blinking (On for 1
sec, Off for 1 sec)
The wireless module of the NWA1000 Series is disabled or
failed.
Red On There is system error and the NWA1000 Series cannot
boot up, or the NWA1000 Series suffered a system failure.
Fast Blinking (On for 50
ms, Off for 50 ms)
The NWA1000 Series is doing firmware upgrade.
Slow Blinking (Blink for 3
times, Off for 3 sec)
The Uplink port is disconnected.
Management Green/
Amber
Off The NWA1000 Series is in standalone mode.
UPLINK Amber/
Green
On Amber - The port is operating as a 10/100-Mbps
connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The NWA1000 Series is sending/receiving data through
the port.
Off The port is not connected.
WLAN Green On The 2.4 GHz WLAN is active.
Off The 2.4 GHz WLAN is not active.
To Next Page
Loading...
